Does anyone have live link for downloading the software Thanks.Im looking for the Software to edit the pushbottons at the PC (WIN XP).
Denon-Germany hasnt distributed the Software and Denon-USA doesnt support the RC-8000 at this time. Pc Bematech Rc 8000 Update The RCMy Software version at the RC-871 is 2.00 Is it possible to send me the PC-Software if you have one Do you now, if I update the RC-871 (greater 2.00) always Best regards, ToniA. My RC-871 software is the following: 3.13 - thats info from Setup 34 page information PM me your e-mail and Ill send you the file (2.9MB exe) regards, MS. Pc Bematech Rc 8000 Serial I FoundI have an AVC A1SE with the RC 871 remote I have downloaded the RC 8000 software from the Denon US site using a serial I found on Google. I loaded it on an XP computer (doesnt seem to work on Vista 64) and plugged in the USB. Pc Bematech Rc 8000 Driver Wizard AtPointed the update driver wizard at the 8000 program folder and loaded fine. Then I loaded up the editor program and backed up my remote - no probs. It asked me if I wanted to convert it to V3.0 so I ticked yes (big mistake I think) Then I tried a restore just to test it worked ok and it downloaded the backup but all I have now is a blank SYS Call page on the remote, and that is it. Any thoughts or help wrt a system recovery would be appreciated. After that i tried to make a update to v 3.x. By 58 the update stoped, the programm dont responce anymore. If i connect it to the computer, windows reconiced the remote. I had to use a PC with windows xp to get the software working correctly (rather than Vista) What happened to you, sounds very similar to my experience moving from 1.x to 3.x, which I have outlined in this forum. Have you followed the sequence that I posted previously in this thread. Can you please confirm that you have done the following in sequence; 1 Have you reset remote by pressing the sunken button in the battery compartment 2 Have you downloaded the default file supplied with the editing sw to the handset 3 Then and only then upgrade the handset to version 3.13 which came with the software bundle download. If you have not done so I suggest you do and retry the firmware upgrade. Is that enough Or must I hold it for half a minute or something I try it both but without success. Is there some old software (1.x or 2.x) to try send to the remote Maybe if I have the old softwarefirmware that it will work.
0 Comments
Leave a Reply. |